2. SPECIFICATIONS
KE-430F, BE-438F
10
Sewing size (mm)
No.
No. of holes
in button
Pattern
No. of
threads
No. of
crossover
stitches
No. of
stitches
X Y
*1
64
6-6 1 18 3.4
*3
21
6-6 1 19
*3
34
10-10 1 27
*3*4
22
6-6 0 24
*3*5
43
6-6 0 24
*3*4
35
10-10 0 32
*3*5
44
10-10 0 32
2.4
3.4
46 6-7 1 19
47 8-9 1 23
48 10-11 1 27
49
4
12-13 1 31
3.4 3.4
*1 Use for buttons with small holes.
*3 Do not use the button lifter spring.
*4 When sewing of one side is completed, the button clamp rises and the thread is trimmed. To finish sewing, press the foot
switch until sewing of the other side starts, or press the foot switch again after sewing of the other side is completed.
*5 When sewing of one side is completed, the thread will be trimmed without the button clamp rising, and then the other
side will be sewn.
For shank button
Sewing size (mm)
No. Pattern No. of threads
No. of
stitches
X Y
50 6 12
51 8 14
52 10 16
53
12 18
3.4 0
Note when creating additional sewing patterns
When sewing data with a small number of stitches (15 stitches or less) is sewn repeatedly (short cycle operation), the
upper shaft motor may overheat and the “E150” error code may be generated.
To Next Page
Loading...
