Brother MFC-440CN - Using Your Remote Access Code

Advanced fax operations (Monochrome only)
83
10
Note
You can change your code at any time by
entering a new one. If you want to make
your code inactive, press Clear/Back in
step e to restore the inactive setting
(---l) and press OK.
Using your Remote Access
Code 10
a Dial your fax number from a touch tone
telephone or another fax machine.
b When your machine answers, enter
your remote access code (3 digits
followed by l) at once.
c The machine signals if it has received
messages:
 1 long beep — Fax messages
 2 long beeps — Voice messages
(MFC-665CW only)
 3 long beeps — Fax & Voice
messages
(MFC-665CW only)
 No beeps — No messages
d When the machine gives two short
beeps, enter a command.
The machine will hang up if you wait
longer than 30 seconds to enter a
command.
The machine will beep three times if you
enter an invalid command.
e Press 9 0 to stop Remote Access when
you have finished.
f Hang up.
Note
If your machine is set to Manual mode
and you want to use the remote retrieval
features, wait about 2 minutes after it
starts ringing, and then enter the remote
access code within 30 seconds. This
function may not be available in some
countries e.g. Australia.