5-42
Confidential
2.4 Continue Mode / Stop Mode Settings of Toner Cartridge
You can set the machine to Continue Mode after "Replace Toner" is displayed on the LCD.
The machine will continue printing until "Toner Ended" is displayed on the LCD. "Stop" is the
default setting.
(1) Press the [Menu] button while the machine is in the ready state.
(2) Press the [ ] or [ ] button to display "General Setup" on the LCD, and press the [OK]
button.
(3) Press the [ ] or [ ] button to display "Replace Toner" on the LCD, and press the [OK]
button.
(4) "Continue" or "Stop" appears on the LCD. (The mode currently set is displayed.)
(5) Press the [ ] or [ ] button to select "Continue" or "Stop".
(6) Press the [OK] button.
(7) Press the [Stop/Exit] button, and the machine returns to the ready state.
2.5 Drum Cleaning
Drum cleaning function overview
Insert the plain paper into the manual feed slot to perform drum cleaning.
<Operating Procedure>
(1) Open the back cover while the machine is in the ready state.
(2) Press the [Clear] and [Menu] buttons at the same time. "Drum Cleaning" appears on the
LCD.
(3) Insert the paper into the manual feed slot.
(4) Drum cleaning is performed with "Please Wait" displayed on the LCD.
(5) The paper is ejected from the back cover, and drum cleaning is completed.
(6) Close the back cover, and the machine returns back to the ready state.
Note:
• Printing is not guaranteed when Continue Mode is set.
• The machine returns to the default setting when the toner cartridge is replaced.
Note:
• When the paper is jammed during drum cleaning, drum cleaning mode is canceled
automatically and the error is displayed.
To Next Page
Loading...
