2-21
Confidential
3.3 Communication Error Codes
Code 1 Code 2 Cause
Refer
to:
10 07 No document detected when calling. 2-82
10 08 Wrong number called. 2-82
11 01 No dial tone detected before start of dialing. 2-82
11 02 Busy tone detected before dialing. 2-82
11 03 2nd dial tone not detected. 2-82
11 05 No loop current detected. 2-82
11 06 Busy tone detected after dialing or called. 2-82
11 07 No response from the remote station in sending. 2-82
11 10 Unobtainable tone detected after dialing. 2-82
17 07 No response from the calling station in receiving. 2-82
20 01 Unable to detect a flag field. 2-82
20 02 Carrier was OFF for 200 ms or longer. 2-82
20 03 Abort detected ("1" in succession for 7 bits or more). 2-82
20 04 Overrun detected. 2-82
20 05 A frame for 3 seconds or more received. 2-82
20 06 CRC error in answerback. 2-82
20 07 Echo command received. 2-82
20 08 Invalid command received. 2-82
20 09
Command ignored once for document setting or for
damping-out at turn-around transmission.
2-82
20 0A T5 time-out error 2-82
20 0B CRP received. 2-82
20 0C EOR or NULL received. 2-82
20 0D
Corresponding command not received although the FIF
command sending bit is ON.
2-82
20 0E EOR command received. 2-82
32 01
Remote terminal only with V.29 capability in 2,400 or 4,800
bps transmission.
2-82
32 02 Remote terminal not ready for polling. 2-82
32 10
Remote terminal not equipped with password function or
its password switch OFF.
2-82
40 02 Illegal coding system requested. 2-82
40 03 Illegal recording width requested. 2-82
40 05 ECM requested although not allowed. 2-82
40 06 Polled while not ready. 2-82
40 07 No document to be sent when polled. 2-82
40 10 Nation code or manufacturer code not correct. 2-82
40 12 Retrieval attempted while not ready for retrieval. 2-82
To Next Page
Loading...
