Brother MFC-8440 - Scan to Image

NETWORK SCANNING (WINDOWS
®
98/98SE/ME/2000 PROFESSIONAL AND XP ONLY) 19 - 6
Scan to Image
When you select Scan to Image your original will be scanned and
sent directly to the PC you designated on your network. The Brother
SmartUI will activate the default graphics application on the
designated PC. You can change the Scan configuration. (For
Windows
®
98/Me/2000: See Scan to Image on page 14-14.) (For
Windows
®
XP: See
Hardware Section: Changing the Scan to button
configuration
on page 15-5 to 15-10.)
1
Place the original face up in the ADF, or face down on the
scanner glass.
2
Press (
Scan
).
3
Press or to select
Scan
to Image
.
Press
Set
.
4
Press or to select a
destination you want to send.
Press
Set
.
If the LCD prompts you to enter a PIN Number, enter the 4-digit
PIN Number for the destination PC on the control panel.
Press
Set
.
The MFC will start the scanning process.
For Network Scanning the Brother Control Center (SmartUI)
selections are used only for configuring the
Scan
button. You
will not be able to initiate a network scan from the Brother
Control Center (SmartUI).
▲
Scan to E-mail
Scan to Image
Scan to OCR
▼
Scan to File
Select
▲▼
& Set