Brother MFC-9320CW - Page 29

29
For Wireless Network Users
Wireless Network
Windows
®
Macintosh
b Manual configuration from the control panel
If your wireless router/access point does not support SecureEasySetup™, Wi-Fi Protected Setup or AOSS™, write
down the wireless network settings of your wireless access point/router.
1
WPA/WPA2-PSK is a Wi-Fi Protected Access Pre-Shared Key, which lets the Brother wireless machine associate with
access points using TKIP or AES encryption (WPA-Personal). WPA2-PSK(TKIP), WPA-PSK(TKIP or AES) uses a Pre-
Shared Key (PSK) that is 8 or more characters in length, up to a maximum of 63 characters.
2
The WEP key is for 64-bit encrypted networks or 128-bit encrypted networks and can contain both numbers and letters.
If you do not know this information you should see the documentation provided with your access point or wireless router.
This key is a 64-bit or 128-bit value that must be entered in an ASCII or HEXADECIMAL format.
3
This is supported for WPA-PSK only
4
Encryption key, WEP key, Passphrase
For LEAP and EAP-FAST, record the User Name and Password
Now go to
page 33
c One push configuration using SecureEasySetup™ ,Wi-Fi Protected Setup or AOSS™
If your wireless router/access point supports automatic wireless (one-push) setup (SecureEasySetup™, Wi-Fi
Protected Setup or AOSS™)
Now go to
page 35
IMPORTANT
If you do not know this information (Network Name, WEP key, WPA2-PSK (Pre-Shared Key), LEAP or EAP-
FAST) you cannot continue the wireless setup. You should see the documentation provided with your
access point or wireless router, consult the router manufacturer, or your system administrator.
Network name:(SSID, ESSID)
Communication Mode Authentication method Encryption mode
Network key
4
Infrastructure Open system
WEP
2
NONE —
Shared key
WEP
2
WPA/WPA2-PSK
1
AES
TKIP
3
LEAP CKIP
EAP-FAST/NONE
EAP-FAST/MS-CHAPv2
EAP-FAST/GTC
AES
TKIP
For example:
64-bit ASCII: Uses 5 text characters e.g. “Hello” (this is case sensitive)
64-bit Hexadecimal: Uses 10 digits of hexadecimal data e.g. “71f2234aba”
128-bit ASCII: Uses 13 text characters e.g. “Wirelesscomms” (this is case sensitive)
128-bit Hexadecimal: Uses 26 digits of hexadecimal data e.g. “71f2234ab56cd709e5412aa3ba“
For example:
Network name:(SSID, ESSID)
HELLO
Communication Mode Authentication method Encryption mode Network key
Infrastructure WPA2-PSK AES 12345678