Brother MFC-J200 - Stop Faxing; Setting Scanner Glass Size for Faxing; Colour Fax Transmission; Cancelling a Fax in Progress

Chapter 4
24
e Press Mono Start or Colour Start.
Faxing from the ADF 4
 The machine starts scanning the
document to be sent.
Faxing from the scanner glass 4
 If you pressed Mono Start, the
machine starts scanning the first
page. Go to step f.
 If you pressed Colour Start, the
machine starts dialling and sending
the document.
f When the LCD asks you Next Page?,
do one of the following:
 To send a single page, press 2 to
choose No(Dial) (or press
Mono Start again).
The machine starts sending the
document.
 To send more than one page, press
1 to choose Yes and go to step g.
g Place the next page on the scanner
glass.
Press OK.
The machine starts scanning the page.
(Repeat steps f and g for each
additional page.)
h After all the pages have been scanned,
press 2 or Mono Start to start.
Stop faxing 4
To stop faxing, press Stop/Exit.
Setting scanner glass size for
faxing 4
When documents are Letter size, you need to
set the Scan Size to Letter. If you do not, the
side portion of the faxes will be missing.
a Load your document.
b Press (FAX).
c Press Menu, 3, 2, 0.
d Press a or b to choose Letter (or A4).
Press OK.
e Press Stop/Exit.
f Enter the fax number.
g Press Mono Start or Colour Start.
NOTE
This setting is only available for sending
documents from the scanner glass.
Colour fax transmission 4
Your machine can send a colour fax to
machines that support this feature.
Colour faxes cannot be stored in the
machine’s memory. When you send a colour
fax, the machine will send it in real time (even
if Real Time TX is set to Off).
Cancelling a fax in progress 4
If you want to cancel a fax while the machine
is scanning, dialling or sending, press
Stop/Exit.