Brother P-Touch 2100 - Entering Barcode Data

EDITING A LABEL
46
Creating a Barcode Label
zBarcode Settingsz
Entering Barcode Data
Press the key.
The Bar Code Input screen is displayed.
Type in the barcode data.
Special characters can be entered in the barcode when
using the CODE39, CODABAR, CODE128 or EAN128
protocols. When not using special characters, go to
step 5.
Press the key.
A list of characters available for the current protocol is
displayed.
Select a character using the or key, then press
the or key to insert the character in the barcode
data.
Press the or key to insert the barcode in the
label.
Two barcode marks are displayed on the text entry
screen.
Attribute Value
Protocol
CODE39 , CODE128, EAN8, EAN13, EAN128,
UPC-A, UPC-E, I-2/5, CODABAR
Width
Large
Small
Under#
(characters printed
below barcode)
On
Off
C.Digit
(check digit)
Off
On
(only available for the CODE39, I-2/5
and CODABAR protocols)
Up to five bar codes can be entered on a label.
1
2
3
4
5