63
4 Press to engrave the stamp stencil film, and then automatically cut off.
To affix a stamp:
5
Remove the stamp frame from around the stamp film holder ink pad, one side at a
time, then remove the protective seal covering the ink pad and the backing paper
from the stamp stencil film.
6 With the glossy side of the stamp stencil film upward, align one of its ends with the
slit on the side of the stamp film holder.
7 Hold the end of the stamp stencil film in place with your thumb, then pass the tape
through the guides while pulling it tight.
To Next Page
Loading...
