20
5 Double-click the P-touch Editor 3.2 folder
to open it.
6 Double-click the P-touch Editor 3.2
Installer icon in the folder that appears.
The installer starts up.
7 Select the installation method.
•For a basic installation
Clicking the Install button immediately starts installing the all options.
☞ About 20 MB of available hard-disk space is needed to begin installation. In order
to install all options, about 100 MB of available hard-disk space is needed. If
enough hard-disk space is available, click the Install button.
•For a custom installation
Clicking the Custom Install button dis-
plays a dialog box that allows you to
select which options to install.
Only the options with a check mark
beside them are installed. Select the
options that you wish to install, and then
click the Install button.
☞ In order to print from the P-touch
2600/2610, “PT-2600/2610 Driver”
must be selected for installation.
If certain options are not installed,
some P-touch Editor functions may not be available.
8 When the dialog box appears, indicating
that the installation is finished, click the
Quit button.
To Next Page
Loading...
