52
In order for one section of the text to have a different number of lines than the rest of the text
or in order to apply a different format to a section of the text (Refer to LOCAL FORMAT FUNC-
TION on page 77.), a new block must be created using the New Block function.
☞ A single label can only contain a maximum of five blocks. If the cursor is located in the
fifth block when c is held down and _ is pressed, the error message “5 BLOCK
LIMIT!” appears.
If the cursor is positioned in the middle of a text block when c is held down and
_ is pressed, the block splits into two and the character to the left of the cursor’s
current position becomes the end of the block.
To add a new block:
● Hold down c and press _ once. The new block mark ( ) appears in the text to
indicate the end of the block.
EXAMPLE
To add a new block:
● Hold down c and press _ once.
NEW BLOCK KEY
TZ-Tape
AV-Label
1:
K’s bar_
1:
_
1:
K’s bar
To Next Page
Loading...
