54
Ch. 3 Functions
Functions
In addition, if the Text Rotation function is set to
OFF, the text will align within the length set
with the Block Length function. If the Text Rota-
tion function is set to any setting other than
OFF, the text will align within the width of the
tape. The alignment of the text at the cursor’s
current position is shown at the top of the dis-
play.
To change the setting for the Text Align-
ment function:
1 Hold down d and press 1, 2 or 3.
2 Press j or k until ALIGNMENT is dis-
played. The setting for the text at the cur-
sor’s current position is shown on the left
side of the display and a sample can be
seen on the right side.
3 Press m or g until the desired setting is
displayed.
4 Press n to apply the setting.
Text Rotation function (ROTATE)
Any text block with the Text Rotation function
applied is rotated 90
°
counterclockwise. By
selecting the &REPEAT setting, the text is repeat-
edly printed for the length of the text block.
NOTE
This step may be skipped if settings for several for-
mat functions are being applied at the same time.
Length Margin Font Width Size
1 2 3 4 5 6 7 8 9
A B C D E F K
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
R
R
R
R
R
R
G
H
I
J
L
M
NO
AUTO 1.10 HELSINKI A AUTO
<<< P-touch >>>
1
:
_
Length Margin Font Width Size
1 2 3 4 5 6 7 8 9
A B C D E F K
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
R
R
R
R
R
R
G
H
I
J
AUTO 1.10 HELSINKI A AUTO
08/13
ALIGNMENT
LEFT
L
M
N
NOTE
☞
If “*****” appears as a setting, the Text Align-
ment function has already been applied to
either a line in the current text block (if the
Block Format or the Global Format function is
being set) or a block in the current text (if the
Global Format function is being set). Changing
the setting will cancel the setting that was previ-
ously applied.
☞
To return the function to its default setting
(LEFT), press the space bar.
☞
To return to the text without changing the for-
matting, press
e
(OR hold down
d
and
press
1
,
2
or
3
).
NOTE
To apply several format settings at the same time,
continue pressing j or k to select the function,
then pressing m or g to select the desired setting.
Press n only after the necessary functions have
been set.
OFF
ON
&REPEAT
To Next Page
Loading...
