16
Entering and Editing Text
EDITING A LABEL
Entering and Editing Text
Entering Text from the Keyboard
Adding a New Line
Move the cursor to end of the current line and press ( ).
NOTE
• There is a maximum number of lines of text that can be entered for
each tape width. A maximum of 7 lines for 24 mm tape, 5 lines for
18 mm tape, 3 lines for 12 mm tape, 2 lines for 9 mm and 6 mm tape,
and 1 line for 3.5 mm tape.
• When [Input Mode] is set to [Label View], if you press ( ) to add
a new line and there is already a maximum number of lines of text that
can be entered for the tape you are using, [Too Many Lines!] is
displayed. When [Input Mode] is set to [Print Preview], if you press
( ) and seven lines already exist, [Too Many Lines!] is displayed.
Press ( ) or any other key to clear the error message.
Adding a New Block
To create a new block of text/lines to the right of your current text, press
( ) and ( ). The cursor moves to the start of the new block.
NOTE
• A maximum of 5 blocks can be entered in one label.
• If you press ( ) and ( ) when five blocks already exist, [Too
Many Blocks!] is displayed. Press ( ) or any other key to clear the
error message.
Deleting Text
By pressing ( ), the letters will be deleted one by one.
To delete all text:
() Î / [Create Label] Î () or ( ) Î Enter the character.
Line 1 Line 2 Label image
() Î / [Text Only] Î () or ( ).
To Next Page
Loading...
