BASIC USAGE
You can enter a maximum of 80 characters and
spaces for a text label, and 50 characters and
spaces if using templates.
To cancel any operation, press .
After pressing , [Accepted] appears on the
LCD for approximately one second.
X Switching Upper Case / Lower Case
X Creating Two-Line Ribbons / Tapes
Move the cursor to where you want to start the next
line and press . Use either 0.35" (9mm) or 0.47"
(12mm) tape for two-line printing.
NOTE
• The return symbol ( ) appears when you press
the Enter key .
X Entering Tabs
• The tab symbol appears when you insert a
tab in the text.
X Changing Tab Length
• To return to the default tab length, press
.
• Please note : the default length varies based on
your ribbon or tape size.
X Cursor Keys
To move to the end of your text:
+
To move to the beginning of your text:
+
X Entering Accented Characters
• Refer to the Accented Characters table in this
guide.
• The order of accented characters varies based
on the language you selected.
X Changing Ribbon / Tape Length
NOTE
• After printing a ribbon, cut along the printed dots
(:) with scissors so the ribbon length matches
what is shown on the LCD.
• The lock symbol appears when you set a
specific ribbon/tape length.
• To return to the default length (automatic, based
on text length), press , and [Auto]
appears on the LCD.
X Clearing Text and Settings
To delete individual letters and spaces, press .
To delete all text :
To delete all text and settings :
Entering Text
To Next Page
Loading...
