X Setting Margins
[
Full
] / [
Half
] / [
Narrow
]
Use one of these options to customize margin length
before and after your text.
• The printed dots (:) indicate the end of the label.
Cut along the printed dots (:) with scissors.
[
Chain Print
]
(ribbon/tape-saving option)
Use this option to print multiple different labels with
narrow margins. This option saves ribbon/tape.
1. Enter your text.
2. Press . [Copies] appears on the LCD.
3. Press the number keys to enter the number of
copies you want of this text.
4. Press to start printing.
5. When [Feed OK?] appears on the LCD, press
to change the text.
6. Clear the text, enter the text you want on the
next ribbon/tape, and then press .
7. After your last ribbon/tape prints, when [Feed
OK?] appears on the LCD, press .
NOTE
• When you use [
Chain Print
], feed the ribbon/
tape before using the cutter ( + ),
otherwise part of the text may be cut off.
• Do not pull the tape, as this may damage the Tape
Cassette.
• The printed dots (:) indicate the end of the label. Cut
along the printed dots (:) with scissors.
You can save and reuse the text and settings for up
to 20 different labels. Each ribbon/tape holds up to
80 characters (including spaces). Assign a number
(1-20) to each saved file so you can reuse it, and edit
or overwrite stored files as needed.
X Saving a new file
NOTE
• When saving a file, if you reuse a number that is
already assigned to another file, [
Overwrite OK?
]
appears on the LCD. To overwrite the previously-
saved file, press . To cancel without saving,
press .
X Printing a saved file
X Opening a saved file
Printing Ribbons / Tapes (cont)
/ [Margin]
/ [Full / Half / Narrow /
Chain Print]
LCD Printout
Full
Half
Narrow
To Next Page
Loading...
