NOTE
• When you set [Chain Print], feed the ribbon/tape
before using the cutter, otherwise a part of the
text may be cut off.
• When you set [Half] or [Narrow], the displayed
ribbon/tape length is the length from the printed
dots () to the end of the label. Cut along the
printed dots (:) with scissors.
• To print more than one copy of a label with
minimum margins, set the margin to [Narrow].
• Do not pull the tape because this may damage
the tape cassette.
You can save up to 15 labels and recall them
for printing at a later date. A maximum of
80 characters can be saved per file, a maximum
of 1200 characters can be saved in total memory.
You can also edit and overwrite the stored labels.
Save
Print
Open
NOTE
• You can also enter the File menu by pressing
.
• If you try to store a label when there is already
a label stored to that number, a message
“Overwrite OK?” appears. Press to save
your new label. Press to cancel.
• You must enter some text before using the save
function.
Printing Ribbons/Tapes
(continued)
LCD Printout
Full
Half
Narrow
ABC
67 mm
ABC
25 mm
Saving Ribbon/Tape Files
Enter Text / [File]
/ [Save] /
/ [File]
/ [Print] /
[Copies: ]
// -
/ [File]
/ [Open]
/
To Next Page
Loading...
