57
FRAME FUNCTION
With the Frame function, you can choose from various frames and highlights to design a more
decorative or emphasized label.
The following Frame settings are available:
OFF, SQUARE, ROUND, CANDY, POINTING, NAMEPLATE and DOT
The default frame setting is OFF; however, other settings are also available. When any setting
other than OFF is selected, the Undl/Frm indicator on the right side of the display lights up.
☞
If the ON underline setting has already been chosen when a frame or highlight is
selected, the underline setting changes back to OFF and the text is framed or high-
lighted.
Refer to
Reference
at the end of this section for samples of the available settings.
To change the frame setting:
1 While holding down , press once, and keep held down to display the
current frame setting.
2 While still holding down , continue pressing until the desired frame setting is
displayed.
☞
The Undl/Frm indicator lights up when any setting other than OFF is selected.
3 Release to apply the selected frame setting to the entire text.
EXAMPLE
To select the CANDY frame setting:
1
While holding down , press
once, and keep held down.
2 While still holding down , con-
tinue pressing until CANDY is dis-
played.
3 Release .
Frame
Frame
OFF
FRAME
Alt
Caps
Undl/Frm
Length
Wide
Frame
CANDY
FRAME
Alt
Caps
Undl/Frm
Length
Wide
Frame
To Next Page
Loading...
