15
Entering and Editing Text
EDITING A LABEL
Entering and Editing Text
Entering Text from the Keyboard
Adding a New Line
Move the cursor to end of the current line and press ( ).
NOTE
• There is a maximum number of lines of text that can be entered for
each tape width. A maximum of 5 lines for 0.70" (18 mm) tape, 3 lines
for 0.47" (12 mm) tape, 2 lines for 0.35" (9 mm) and 0.23" (6 mm)
tape, and 1 line for 0.13" (3.5 mm) tape.
• If you press ( ) when five lines already exist, [Too Many Lines!]
is displayed. Press ( ) or any other key to clear the error message.
Adding a New Block
To create a new block of text/lines to the right of your current text, press
( ) and ( ). The cursor moves to the start of the new block.
NOTE
• A maximum of 5 blocks can be entered in one label.
• If you press ( ) and ( ) when five blocks already exist, [Too
Many Blocks!] is displayed. Press ( ) or any other key to clear the
error message.
Deleting Text
By pressing ( ), the letters will be deleted one by one.
To delete all text:
To delete all text and format settings:
() Î / [Create Label] Î ( ) or ( ) Î Enter the character.
Line 1 Line 2 Label image
() Î / [Text Only] Î () or ( ).
() Î / [Text&Format] Î ( ) or ( ).
To Next Page
Loading...
