Brother P-Touch PT-E550WNIVP - Cable Flag; Patch Panel

8
1
2
3
4
5
6
7
9
5
Selecting a Labeling Application Type
 EDITING A LABEL
CABLE FLAG
Labels printed with this mode can be wrapped around a cable
or wire, and both ends of the label stick together to form a f lag.
We recommend using Flexible ID Tape for Cable Flag labels.
The text on Cable Flag labels is printed on both ends of the
label, leaving a blank space in the middle that wraps around the
cable. In this mode, you can specify the following items:
• Layout: (The same text is printed on each
block.),
(Two different texts are printed on each block.)
• Flag Length: 1.2" (30 mm), 0.4" (10 mm) - 8.0" (200 mm)
• Cable Diameter: 0.25" (6 mm), 0.12" (3 mm) - 3.50" (90 mm)
• Orientation: (Horizontal), (Vertical)
• Cross-ID: Off, On (See "Setting Cross-ID" on page 6)
PATCH PANEL
Labels printed with this mode can be used to identify various
types of panels. In this mode, you can specify the following
items:
• Block Length: 0.60" (15.0 mm), 0.20" (5.0 mm) - 12.00"
(300.0 mm)
• # of Blocks: 4, 1 - 99
• Separator: (Tic), (Dash), (Line),
(Bold), (Frame), (None)
• Orientation: (Horizontal), (Vertical)
• Reverse: Off, On
• Advanced: Off, On
Adjust block length independently when "Advanced" is set to "On".
• No Margins: Off, On
Set the left and right label margins to zero.
1
1 Flag at least 0.6" (15 mm
)
Horizontal Vertical
Flag
length
Cable
circum-
ference
Flag
length
Flag
length
Cable
circum-
ference
Flag
length
• You can enter up to two bar codes when is selected in flag layout.
• Labels made with Flexible ID Tape are not designed for use as electrical insulation.
1A-B01 1A-B02 1A-B03
Block lengthBlock length
Block length
"Advanced" and "No Margins" cannot be set to "On" at the same time.