BASIC USAGE (Continued)
Using Print Options
[Numbering]
You can print a series of up to nine ribbons/tapes
at a time using auto-numbering. Using this feature
you can automatically increase a selected
number by one after each one is printed. The
numbers of ribbons/tapes you can print at one
time depend on the initial number.
Example: To print copies of a label containing a
serial number (0123, 0124 and 0125)
• Select the highest number you want to be
printed when setting the number.
[Mirror]
Example: Follow the instructions below after
entering "J.SMITH" if you want to
Mirror Print "J.SMITH".
• Use clear tape in [Mirror], so you can read the
labels correctly from the opposite side when
attached on glass, windows or other
transparent surfaces.
Setting Margin ( )
[Full]/[Half]/[Narrow]
For leaving equal margins on both sides of the
text.
[Chain Print]
Use this setting when printing several ribbon/tape
with minimum margins.
1. Enter text.
2. Press , then [Copies: ] appears.
3. Press / or enter a number with
number keys to select the number of copies.
4. Press . Printing starts, and then the
message "Feed OK?" appears.
5. Press to enter more text.
6. Clear the text, enter the text for the next
ribbon/tape, and then press .
7. When the message "Feed OK?" appears after
the last ribbon/tape is printed, press .
8. After the tape is fed, press the cutter lever to
cut off the chain of ribbons/tapes.
Printing Ribbons/Tapes (continued)
Enter numbers / Move the cursor
to the number you want to increment
+
/ [Numbering]
/
Enter text/characters +
/ [Mirror] [Mirror Print?]
/ [Margin]
/ [Full/Half/Narrow/Chain Print]
4 mm4 mm
ABC ABC
12 mm 12 mm
ABC
25 mm 25 mm
To Next Page
Loading...
