Brother P-Touch QL-570 - APPENDIX 1.3 Use Procedure of the VR Adjustment Tool (Ql500 Tstvradjust.exe)

APPENDIX 1.3 Use Procedure of the VR Adjustment Tool
(ql500tstVRAdjust.exe)
Be sure to make this adjustment in any of the following cases:
-
When you replace the main PCB ASSY
-
When you replace the tape sensor PCB ASSY
-
When you replace the media PCB ASSY
-
When the tape sensor check in the maintenance software tool (ql570tstSE.exe) failed
<Operating Procedure>
(1) Start the VR adjustment tool. (File name: ql500tstVRAdjust.exe)
The following screen appears. (Fig. 33)
Fig. 33
(2) Connect the machine to your PC with the USB cable and turn the ON/OFF button ON.
Note: When new hardware is detected and the “New hardware detection wizard” screen
appears, press the [Cancel] button.
25