APPENDIX 1.4 Auto Power-OFF Setting Tool
(autopoff.exe)
Be sure to use this tool to change the auto power-off setting for all models satisfy conditions
below.
1.
Russian model.
2.
Mounted main PCB ASSY is "LBC080001 (parts code)".
Note: This tool must be used after running the maintenance software tool (ql570tstSE.exe).
Performing in wrong order would cause invalid auto power-off setting in the product.
<Operating Procedure>
This tool sets auto power-off time on products with Erp-Tier2 -compliant PCB for particular
destination.
(1) Connect the machine to your PC with the USB cable and turn ON the machine.
Note: Be sure to install the driver in advance as it is required for this tool.
(2) Once the driver is installed, double-click "autopoff.exe" to run auto power-off setting tool.
This tool can be found in "autopoff100.zip" with other tools. Extract and double-click to
start it.
(3) Once the tool starts, select the connected Printer in the "Printer:" field of the tool. Select
"None" in the "Auto power-off time:" field, and press the [Apply] button.
Select the printer.
Double-click on this icon.
Fig. 42 Auto power-off setting tool
31
To Next Page
Loading...
