Brother P-Touch QL-570 - 8 ] Removing the Upper Cover

 III-
19
[ 8 ] Removing the Upper Cover
(1) Remove the two screws A and three screws B from the upper cover.
(2) Release the three hooks to remove the upper cover from the under cover.
Note: The screws A are screw, bind B M2.6x4. The screws B are taptite, bind B M2.6x6.
Fig.3.1-28 Removing the Upper Cover (1)
(3) Turn the upper cover upside down, and remove the filament tape which secures the
harness of the tape sensor PCB ASSY.
Fig.3.1-29 Removing the Upper Cover (2)
Screws B
Screws A
Upper cover
Under cover
Hooks
Hook
Filament tape
Upper cover
Tape sensor PCB
A
SSY harness