Brother PE-Design Next - Page 180

178
Using the Link Function to Embroider From the Computer
4. Click 1, then 2, then 3.
(1) Transferred design
(2) Queue: Displays the data before it is
transferred to the embroidery machine.
 When the machine is ready to start
loading the data, data transfer begins.
While the data is being transferred, a
message appears in the screen of the
embroidery machine, and the design
moves to the transferred design area.
5. After the design has been transferred, press
the start/stop button on the embroidery
machine to begin embroidering.
When embroidering is started, the following appears
in the Link dialog box.
(1) Shows the status of the embroidery
machine.
Each status indication is described below
a Note:
If the data sent from Layout & Editing does
not appear in the transferred design box,
continue the operation by using the
machine's operation panel.
b Memo:
If you want to send more than one design to
the
Link dialog, repeat step 4 for each design.
The
Link dialog will remain open while the
selected design from Layout & Editing will be
sent to the Link.
3
1
2
(1)
(2)
b Memo:
The transferred data cannot be edited from
the embroidery machine. The received data
can only be embroidered. However,
embroidering settings can be specified.
Status Description
Ready Press the button on the
embroidery machine (Start/
Stop button) to start sewing.
Waiting If there is no data in the queue
(2), select Link as the
destination in the application,
and send data.
If this is the status even though
there is data in the queue (2),
continue the operation by using
the machine's operation panel.
Sewing The machine is sewing.
Paused The machine has temporarily
been stopped.
Color change Change the thread spool on the
machine.
Check thread Check the bobbin thread or the
upper thread on the machine.
Check frame Install a different embroidery
frame on the machine.
Error Check the details of the error
that occurred on the machine.
(1)
XE8656-001.book Page 178 Monday, May 24, 2010 5:44 PM