Brother PE-Design Next - Reshaping Outlines

188
Basic Design Center Operations
Click the start point (1), and then click the next
point (2).
 A line is drawn connecting the two points.
Continue clicking to draw additional lines.
Double-click the end point.
■ Reshaping outlines
Click 1, then 2.
Click an outline.
To add a point, click the outline (1).
To create a corner, drag the point (2).
If the point is deleted, the corner is removed.
Click the point (1), and then press the
key, or click 2.
b Memo:
• To remove the last point that was entered,
right-click.
• To draw vertical or horizontal lines, hold
down the key while moving the
pointer.
b Memo:
Sewing attributes cannot be applied to regions
if the region is not completely enclosed in an
outline.
2
2
1
Shift
3
1
1
2
2
Point
Line appears in pink
3
1
2
4
Delete
2
1
XE8656-001.book Page 188 Monday, May 24, 2010 5:44 PM