Brother PE-Design Next - Page 37

35
Tutorial 2: Drawing shapes to create an embroidery design
Basic Layout & Editing Operations
(B) Right-click the leaves, and then click
Align, then Top.
Step 3 Specifying hole sewing
Now, we will draw the flower and a circle at the
center. Then, we will apply a setting so that the
overlapping areas are not sewn twice.
Draw the flower petals.
(A) Click 1, then 2, then 3.
(B) Select RED in the color palette as the line
color and Zigzag Stitch as the sew type
(4).
(C) Select PINK in the color palette as the
region color and Radial Stitch as the sew
type (5).
(D) While holding down the key, drag
(6) the pointer in the Design Page to draw
flower petals of the desired size, as
shown in the illustration.
Draw the circle at the center.
(A) Click 1, then 2, then 3.
(B) Select YELLOW in the color palette as
the line color and Zigzag Stitch as the
sew type (4).
(C) Select YELLOW in the color palette as
the region color and Concentric Circle
Stitch as the sew type (5).
(D) While holding down the key, drag
(6) the pointer in the Design Page to draw
a circle with the desired size at the center
of the flower, as shown in the illustration.
(E) Drag the circle to the center of the flower
petals.
b Memo:
• Multiple embroidery patterns can be
selected in any of the following ways.
• Click the first pattern, and then, while
holding down the key, click the next
pattern.
• Drag the pointer to draw a selection frame
around the patterns to be selected.
• Click
Mirror in the Arrange tab to create
mirror copies.
c
“Using the Mirror Copy tool” on
page 53.
1
1
2
3
5
4
6
Shift
2
1
2
3
4
6
5
Shift
XE8656-001.book Page 35 Monday, May 24, 2010 5:44 PM