Brother PE-DESIGN V7 - Transferring the Design to an Original Card

21
Tutorial
Click Save.
Step 5 Transferring the design to
an original card
By writing a design to a media that can be used in
your sewing machine and transferring it to your
sewing machine, you can actually sew the design.
For this example, we will transfer the design to an
original card.
Insert an original card into the USB card
writer module.
Transfer the embroidery design.
Click File, then Write to Card.
→ The following message appears.
Click OK.
→ The following message appears.
Click OK.
Quit Layout & Editing.
Click File, then Exit.
b Memo:
You can also use Floppy Disks, Compact
Flash Card, and USB Media to save designs.
a Note:
The original card is inserted correctly when
you hear it snap into place.
1
2
a Note:
Before using the original card, make sure
that the designs on the card are no longer
needed or make sure to store them on your
hard drive or other storage media.
a Note:
• If the card writer module is not correctly
connected or powered, or if the original
card is not inserted or is defective, an error
message of “No card writer module is
connected. Please connect card writer
module.” will appear.
• If the original card is not inserted or is
defective, an error message of “No
original card is inserted. Please insert an
original card.” will appear.
3