35
Tutorial
→ The line image is displayed in the Design
Page.
Step 3 Editing the outlines (Line
Image Stage)
At this time, you might need to correct a few lines
in the line image. You should make sure that
regions are completely enclosed by either a single
closed line or intersecting lines. Here, we will try
to simply draw more leaf veins and to erase a
number of leaves.
After editing the line image, we will continue to the
Figure Handle Stage, where the line image is
converted to a figure handle image.
This draws more leaf veins.
Click .
→ When the pointer is moved over the work
area, the shape of the pointer changes to
.
Click the leaf for which you want to draw more
veins.
Click .
1
b Memo:
• To further enlarge the line image, continue
clicking the line image.
• To zoom in on a specific area, move the
pointer near the desired area, and then drag
the pointer diagonally over the desired area.
A dotted box appears as you drag the
pointer, and the selected area is enlarged
when the mouse button is released.
• To zoom out from the line image, click ,
and then click the line image.
To Next Page
Loading...
