Button Functions
Installing the Rechargeable Li-ion Battery
1. Move battery latch 1 to the unlock position.
2. While holding battery latch 2 in the unlock position, remove the charging
terminal protection case.
3. Release battery latch 2.
Battery latch 2 moves back to the lock position.
4. Insert the rechargeable Li-ion battery into the battery cavity until it locks
into place.
5. Move battery latch 1 to the lock position.
Removing the Rechargeable Li-ion Battery
1. Move the battery latches to the unlock position, and then remove the
battery.
2. Insert the charging terminal protection case into the battery cavity until
it locks into place.
3. Move battery latch 1 to the lock position.
Charging the Rechargeable Li-ion Battery
1. Turn the printer off and install the rechargeable Li-ion battery.
2. Use the AC adapter and AC power cord to connect the printer to an
AC power socket, or use the car adapter to connect the printer to a
DC power socket.
3. When the rechargeable Li-ion battery is fully charged, the STATUS
indicator turns off. Disconnect the AC adapter or car adapter from the
DC connector.
Stopping Rechargeable Li-ion Battery Charging
To stop the battery charging, disconnect the AC adapter or car adapter from
the DC connector.
(Power) button function
Operation
Turn the printer on Press and hold the button for about one second
until the POWER indicator turns on.
Turn the printer off Press and hold the button for about one second
or press it quickly two times depending on the
printer setting (see the Online User’s Guide for
more information).
(Feed) button function
Operation
Feed paper Load the paper and press the button to feed the
paper.
Print the printer settings To print the printer settings without connecting
the printer to a computer or mobile device:
1 Turn the printer on and make sure no paper
is loaded.
2 Press and hold the button until the DATA
indicator lights in red.
3 Load paper.
(Bluetooth) button function
(PJ-762/PJ-763/PJ-763MFi
only)
Operation
Enable/disable the
Bluetooth function
Press and hold the button for one second to
enable or disable the Bluetooth function of the
printer.
(Wi-Fi) button
function (PJ-773 only)
Operation
Enable/disable the Wi-Fi
function
Press and hold the button for one second to
enable or disable the Wi-Fi function of the
printer.
Use WPS to configure
Wi-Fi settings easily
Press and hold the button for about five seconds
to configure the Wi-Fi settings using WPS.
Use the Rechargeable Li-ion Battery
(Optional)
1 Battery latch 1
2 Battery latch 2
3 Charging terminal protection case
4 Battery cavity
5 Rechargeable Li-ion battery
4
5
1 Battery latches
• Charge the rechargeable Li-ion battery immediately after purchase
using the following procedure.
• Up to three hours are needed to fully charge a rechargeable Li-ion battery.
When fully charged, the battery allows you to print about 600 pages.
1 POWER indicator
2 STATUS indicator
Notes on Using the Rechargeable Li-ion Battery
Fully charge the battery before use. Do not use it before it is fully
charged.
Dark printing discharges the battery faster than light printing.
Adjust the print density setting in the printer driver’s dialog box or Printer
Setting Tool (see the Online User’s Guide).
The battery charging must take place in 0 - 40 °C environments,
otherwise the battery will not be charged, and the STATUS indicator will
remain lit.
If you use the printer when both the battery is installed and the
AC adapter or car adapter is connected, the STATUS indicator may turn
off and charging may stop even if the battery has not been fully charged.
Rechargeable Li-ion Battery Characteristics
To ensure the highest performance and longest life from your rechargeable
Li-ion battery:
Do not use or store the battery in a location exposed to extreme high or
low temperatures as it may discharge more quickly. This may happen
when using a rechargeable Li-ion battery with a high charge (charged
90% or more) in a location exposed to high temperatures.
Remove the battery when storing the printer for long periods of time.
Store batteries with less than a 50% charge in a cool dry place out of
direct sunlight.
Recharge the battery every six months if it is stored for long periods of time.
1
To Next Page
Loading...
