Brother PJ-822 - Install the Rechargeable Li-Ion Battery

Home > Set Up Your Printer > Install the Rechargeable Li-ion Battery
Install the Rechargeable Li-ion Battery
1. Slide Battery Latch 1 (a) to the unlocked position.
2. While holding Battery Latch 2 (b) in the unlocked position, remove the Battery Cavity Mounting Block (c).
b
c
a
a. Battery Latch 1
b. Battery Latch 2
c. Battery Cavity Mounting Block
3. Release Battery Latch 2.
4. Insert the Rechargeable Li-ion Battery (a) into the Battery Cavity (b) until it locks into place.
b
a
a. Rechargeable Li-ion Battery
b.
Battery Cavity
5.
Slide Battery Latch 1 to the locked position.
• The voltage supplied by the Rechargeable Li-ion Battery may vary. The printing speed may also vary
depending on the voltage.
• When using the Rechargeable Li-ion Battery, the Battery Cavity Mounting Block is not required. Keep it
in a safe place to avoid losing it.
20