Home > Install Software > Connect the Printer to a Computer or Mobile Device > Connect the Printer to a
Computer Using Wi-Fi > Connect the Printer to a Computer Using a Wi-Fi Router/Access Point (Infrastructure
Mode)
Connect the Printer to a Computer Using a Wi-Fi Router/Access Point
(Infrastructure Mode)
Related Models: PJ-883
Infrastructure Mode allows you to connect the printer to a computer or mobile device via a Wi-Fi router/access
point.
Before You Begin
Configure the printer's Wi-Fi settings to communicate with your Wi-Fi router/access point. After the printer is
configured, the computers and mobile devices on your network will have access to the printer.
• Before connecting the printer to your network, contact your system administrator to confirm your Wi-Fi
network settings.
• To reconfigure the Wi-Fi settings, or if the status of the printer's Wi-Fi connection is unknown, reset the
printer's Wi-Fi settings.
1. Turn off the printer.
2. Press and hold the Feed button
and the Power button for about two seconds.
3. While holding down the Feed button , press the Power button two times, and then release the
Feed button .
The Power indicator starts flashing in orange .
4.
Press the Feed button twice.
• To achieve the best results with normal everyday printing, use the printer as close to the Wi-Fi router/access
point as possible with minimal obstructions. Large objects and walls between the two devices, as well as
interference from other electronic devices, can affect the transfer speed of print data.
Connect the Printer to Your Wi-Fi Router/Access Point
1. Write down the SSID (Network Name) and Password (Network Key) of your Wi-Fi router/access point.
2. Connect the printer and computer using a USB cable.
3. Press the Bluetooth and Wi-Fi button
on your printer to turn the Wi-Fi function on.
• Make sure the Bluetooth and Wi-Fi indicator
starts flashing in green or cyan once every
three seconds.
• If the Bluetooth and Wi-Fi indicator is flashing in blue , press and hold the Bluetooth and Wi-Fi
button for about three seconds. The flashing color changes each time you press and hold the
Bluetooth and Wi-Fi button .
4. Configure the Infrastructure Mode settings of the printer.
• Using a Windows computer:
a. Start the Printer Setting Tool on your computer, and click the Communication Settings button.
b. Click the General tab, and in the Selected Interface section, select Infrastructure.
c. Click the Wireless LAN tab, and in the Wireless Settings section, go to Communication Mode and
select Infrastructure.
d. Click the Wireless LAN tab and select Wireless Settings
. Type the SSID that you wrote down, or
click Search and select the SSID from the list that appears.
e. In the Password field, type Passphrase.
37
To Next Page
Loading...
