26
MELSEC iQ-F Brother Label Printer Sample Program Reference Manual
6. Sequence program outline
6.1. Function outline
This chapter explains the use example of the print operation using Brother label printer based on the
information from the Mitsubishi programmable controller (MELSEC).
6.2. Program outline
This program can transmit the following P-touch Template commands to the label printer just one time
communication.
For the explanation of each command, refer to Each command explanation
in [Appendix A].
Command Content
1 ESC 'ia' 03h Changing the mode inside the printer to "P-touch Template mode"
2 '^II' Initialization
3 '^TS001' Selecting template number "1"
4 '^SS01,' Setting a separator to ',' (comma)
5 Filling data Concatenated string from obj0001-obj0004
6 '^FF' Printing start
For example, filling data of 5 is the following data string.
For the corresponding object name, refer to the drawing in 3.2.2 Object name list
.
String of object
number 1
,
String of object
number 2
,
String of object
number 3
,
String of object
number 4
,
By printing the data shown above in each page, change the data a little so that total 3 pages of printing will be
completed.
To Next Page
Loading...
