This setting is valid only in Ad-hoc mode.
4. Authentication Method / Encryption Mode
The supported encryption modes for the various authentication methods are as shown in Communication Modes and Authentication Methods / Encryption Modes.
5. WEP Key
You can only specify a setting when WEP is selected as the encryption mode.
6. Passphrase
You can only specify a setting when WPA/WPA2-PSK is selected as the authentication method.
7. User ID / Password
You can only specify settings when LEAP, EAP-FAST, PEAP, EAP-TTLS or EAP-TLS is selected as the authentication method. In addition, with EAP-TLS, it is not necessary to register a password, but a client
certificate must be registered. To register a certificate, connect to the printer from a web browser, and then specify the certificate.
8. Display the key and password on-screen
If this check box is selected, keys and passwords will be displayed in plain text (non-encrypted text).
Communication Modes and Authentication Methods / Encryption Modes
When [Communication Mode] is set to [Ad-hoc]
Authentication Method Encryption Mode
Open System None / WEP
When [Communication Mode] is set to [Infrastructure]
Authentication Method Encryption Mode
Open System None / WEP
Shared Key WEP
WPA/WPA2-PSK TKIP+AES / AES
LEAP CKIP
EAP-FAST/NONE TKIP+AES / AES
EAP-FAST/MS-CHAPv2 TKIP+AES / AES
EAP-FAST/GTC TKIP+AES / AES
PEAP/MS-CHAPv2 TKIP+AES / AES
PEAP/GTC TKIP+AES / AES
EAP-TTLS/CHAP TKIP+AES / AES
EAP-TTLS/MS-CHAP TKIP+AES / AES
EAP-TTLS/MS-CHAPv2 TKIP+AES / AES
EAP-TTLS/PAP TKIP+AES / AES
EAP-TLS TKIP+AES / AES
To perform higher level security settings:
When performing certificate verification with EAP-FAST, PEAP, EAP-TTLS or EAP-TLS authentication methods, the certificate cannot be specified from [Printer Setting Tool]. After the printer is
configured to connect to the network, specify the certificate by accessing the printer from a web browser.
Wireless Direct Tab
Wireless Direct Settings
1. SSID / Network Key Generation
Select [AUTO] or [STATIC].
To Next Page
Loading...
