Error Message Cause/Solution
Print Data Too Large
• The printer receives a print job exceeding the maximum print length.
• Print jobs exceeding 3 m and incompatible files cannot be printed.
Recharge Battery!
Does the rechargeable battery have a low charge?
Use the AC Adapter and AC power cord to connect the printer to an electrical
socket, or use the car adapter to connect the printer to a DC power socket to
charge the battery.
You can also charge the battery using a USB cable (not included).
System Error! XX
If the error message is displayed, contact Brother customer service.
WPS did not connect 1 Try
to connect again
WPS did not connect 2 Try
to connect again
The Wi-Fi router/access point could not be found or multiple Wi-Fi routers/
access points were found.
• Confirm that only one Wi-Fi router/access point within range has the WPS
method active and try again.
• Try again after a few minutes to avoid interference from other routers/access
points.
Related Information
• Troubleshooting
Related Topics:
• Load the Roll
167
To Next Page
Loading...
