Brother RJ-3230B - Page 198

The upper tear bar and lower tear bar cannot be used when the Label Peeler is installed.
4. Peel off a few labels. Then, set the Roll so that the next label does not cover the Media Sensor area.
a
a. Media sensor
5. Close the Roll Compartment Cover.
6. Lightly pull on the paper in the Paper Exit Slot to remove any slack in the roll.
IMPORTANT
• Before using the Label Peeler, specify the following settings:
- Set Exit Position to Peeler in the Basic tab of the Printer Setting Tool.
- Select the Use Peeler Function check box on the Basic tab of the printer driver properties. For more
information, see Related Topics.
• When not using the Label Peeler, specify the following settings:
- Set Exit Position to [Tear Bar] in the Basic tab of the Printer Setting Tool.
- Clear the Use Peeler Function check box on the Basic tab of the printer driver properties.
194