Brother RJ-3230B - Page 30

5. If the LCD shows [Select Media] or [Auto Detect], select the option you want. To configure these
settings later, go to the [Media].
NOTE
For best performance, use genuine Brother media.
• When using die-cut labels, set the paper type to Die-cut Label, and press the (Feed) / OK button
after inserting the roll. The printer will feed the label to the top of form position.
• To remove the roll, reverse the loading procedure.
• Make sure the inserted roll turns freely between the Roll Guides.
Change the Media Roll Holders to Use Custom-Size Media
To use custom-size media, attach the Media Roll Holders that match your media's core size to the Roll Guides.
NOTE
• Not all types of Media Roll Holders may be supplied with your printer. To purchase additional Media Roll
Holders, contact your local Brother dealer.
• To check which media core sizes each Media Roll Holder supports, check the information on the centre of
the Media Roll Holder.
• If using multi-size Media Roll Holders, make sure the same-size sides face each other when attached to
the Roll Guides.
1. Push the Roll Cover Release Lever to open the Roll Compartment Cover.
2. Hold the left Roll Guide so that it does not rotate, and then remove the currently installed Media Roll Holder
using a flathead screwdriver.
3. Hold the right Roll Guide so that it does not rotate, and then remove the currently installed Media Roll Holder
using a flathead screwdriver.
4. Attach the Media Roll Holders that match your media's core size to the Roll Guides using a flathead
screwdriver. Make sure you use the same size Media Roll Holders.
26