P-touch Template 2.0 Command Reference
- 35 -
7. Control Command Details
^PS Specify print start command text string
ASCII: ^ P S n1 n2 data
Decimal: 94 80 83 nd1 nd2 datad
Hexadecimal: 5E 50 53 nh1 nh2 datah
Parameters
0≤n1≤2
0≤n2≤9
00h≤datah≤FFh
Description
z Specifies the text string for the print start command.
(n1*10)+n2: Length of the text string (can be set between 1 and 20)
data: Text string (The maximum number of characters that can be set is 20 characters
(bytes).)
z The default text string for the print start command is “^FF”.
z This command is a dynamic command.
Remarks
z Invalid if more than 20 characters have been specified
Example
z To change the text string for the print start command to “START”:
Since the text string to be specified (data), “START”, contains 5 characters, n1=0 and n2=5. Therefore, the
command will be as follows.
^ P S 0 5 S T A R T
(5Eh 50h 53h 30h 35h 53h 54h 41h 52h 54h)
To Next Page
Loading...
