Brother RJ-4030 - Page 10

Chapter 1
6
c Insert an RD Roll into the RD Roll
compartment upside down with the
labels feeding from the bottom as
shown.
d Align the RD Roll with the guide lines.
4 Guide lines
5 Tear bar
e Close the RD Roll compartment by
pressing on the centre of the cover.
f Press and hold the (Power) button to
turn the printer on.
Note
When using die cut label, press the
(Feed) button after inserting the
RD Roll. The printer will position the label
to the correct starting position.
 Make sure that the position of the
roll guide to prevent the RD Roll
from moving sideways.
 Incorrect insertion of the RD Roll will
not print on the correct side of the
label.
 When printing on die cut labels, set
the roll guide so that there is 2 mm
of space on both sides (4 mm total)
of the scale.
Example: When using a
101.6 mm-wide label, set the roll
guide to a width of 105.6 mm.
Use genuine Brother paper.
5
4