115
The IPsec connection conditions comprise two Template types: Address and IPsec. You can configure up to 10
connection conditions.
1. Start your web browser.
2. Type "https://machine's IP address" in your browser's address bar (where "machine's IP address" is the
machine's IP address).
For example:
https://192.168.1.2
3. If required, type the password in the Login field, and then click Login.
4. Go to the navigation menu, and then click Network > Security > IPsec.
5. Configure the settings.
6. Click Submit.
If the machine must be restarted to register the new settings, the restart confirmation screen will appear.
If there is a blank item in the template you enabled in the Rules table, an error message appears. Confirm your
choices and click Submit again.
Configure IPsec Using Web Based Management
The default password to manage this machine’s settings is located on the back of the machine and marked
"Pwd".
Start from , if the navigation menu is not shown on the left side of the screen.
Option Description
Status Enable or disable IPsec.
Negotiation Mode Select Negotiation Mode for IKE Phase 1. IKE is a protocol that is used to
exchange encryption keys in order to carry out encrypted communication
using IPsec.
In Main mode, the processing speed is slow, but the security is high.
In Aggressive mode, the processing speed is faster than Main mode, but the
security is lower.
All Non-IPsec Traffic Select the action to be taken for non-IPsec packets.
When using Web Services, you must select Allow for All Non-IPsec Traffic.
If you select Drop, Web Services cannot be used.
Broadcast/Multicast Bypass Select Enabled or Disabled.
Protocol Bypass Select the checkbox for the option or options you want.
Rules Select the Enabled checkbox to activate the template. When you select
multiple checkboxes, the lower numbered checkboxes have priority if the
settings for the selected checkboxes conflict.
Click on the corresponding drop-down list to select the Address Template
that is used for the IPsec connection conditions. To add an Address
Template, click Add Template.
Click on the corresponding drop-down list to select the IPsec Template that
is used for the IPsec connection conditions. To add an IPsec Template, click
Add Template.
• Use IPsec
Related Topics:
• Access Web Based Management
• Configure Certificates for Device Security
To Next Page
Loading...
