66
If your wireless access point/router supports WPS (Push Button Configuration), you can use WPS from your
machine's control panel menu to configure your wireless network settings.
1. Press [Settings] > [Network] > [WLAN(Wi-Fi)] > [WPS/Push Button].
2. When [Enable WLAN?] appears, press [Yes].
The wireless setup wizard starts. To cancel, press [No].
3. When the touchscreen instructs you to start WPS, press the WPS button on your wireless access point/ router.
Then press [OK] on your machine. Your machine automatically tries to connect to your wireless network.
If your wireless device is connected successfully, the LCD displays [Connected].
You have completed the wireless network setup. To install the drivers and software necessary to use your machine,
go to your model's Downloads page at https://s.brother/ca2ab/
.
Configure Your Machine for a Wireless Network Using the One Push
Method of Wi-Fi Protected Setup™ (WPS)
• Use the Wireless Network
To Next Page
Loading...
