T-8421C, 8422C, 8452C, 8722C, 8752C
7. USING THE G10 OPERATION PANEL (BASIC OPERATIONS)
39
7-2. Sewing start and end backtack stitches
1
Setting start backtack stitches
2
Setting end backtack stitches
3
Start backtacking is carried out. After it has finished, normal sewing continues for as long as
the treadle remains depressed.
NOTE:
If the treadle is returned to the neutral position, the sewing machine will continue
operating until the set number of start backtack stitches has been sewn.
4
End backtacking is carried out. After it has finished, the thread is trimmed automatically
(models with thread trimmer) and the sewing machine stops in the needle up position.
NOTE:
・ If the treadle is depressed backward before sewing of the set number of start backtack
stitches is complete, end backtacking will not be carried out.
・ If thread trimming lock is set, the sewing machine will stop in the needle up position
without thread trimming being carried out.
2911M
4200M
4201M
For example,
3 stitches and
4 stitches
Example:
2159M
2160M
To Next Page
Loading...
Need help?
General
