T-8421C, 8422C, 8452C, 8722C, 8752C
7. USING THE G10 OPERATION PANEL (BASIC OPERATIONS)
40
7-3. Sewing continuous backtack stitches
1
Setting continuous backtack stitches
2
If the treadle is simply depressed continuously, the number of stitches set for A, B, C and D
will be sewn in a single cycle, the thread will be trimmed automatically (models with thread
trimmer) and then the needle bar will stop in the needle up position.
NOTE:
・ If the treadle is returned to the neutral position while continuous backtacking is being
carried out, the sewing machine will stop at the point where the treadle returns to the
neutral position.If the treadle is depressed again, operation will resume from the point
where it was interrupted.
・ If thread trimming lock is set, the sewing machine will stop in the needle up position
without thread trimming being carried out.
2159M
4202M
2185B
Example:
To Next Page
Loading...
Need help?
General
