T-8421C, 8422C, 8452C, 8722C, 8752C
8. USING THE G10 OPERATION PANEL (ADVANCED OPERATIONS)
42
8-2. Slow start
When the slow start setting is enabled, the two stitches at the sewing start after thread trimming will be sewn at 700 sti/min.
After this, the sewing speed corresponds to the treadle depression amount.
* This setting cannot be carried out if the lock function is on. (For details on turning the lock function off, refer to “8-7.
Lock function”.)
1
Activating setting mode
(While pressing the end backtack key, press the power ON switch.)
2
Selecting “SloW” (slow start)
(Press twice)
3
Enabling and disabling slow start
・ When the key is pressed, the “on”
display will appear.
・ When the key is pressed, the “oFF”
display will appear.
…
Slow start enabled
… Slow start disabled
NOTE:
If the start backtack key (1) is pressed once
more, the start backtack indicator will switch
off and the display will return to the setting
item.
4
The setting will be stored and the display will
return to the setting item.
5
Setting mode will be exited and normal operation will be possible.
4206M
(Setting value)
(Setting item)
(Setting item)
(Setting item)
4207M
4208M 2138M 2139M
4209M
4203M
To Next Page
Loading...
Need help?
General
