T-8421C, 8422C, 8452C, 8722C, 8752C
8. USING THE G10 OPERATION PANEL (ADVANCED OPERATIONS)
46
8-6. Adjusting the needle up stop position
1
(While pressing the key (1), press the power ON switch.)
“MorG” will appear in the display (2).
2
Selecting “UPoS”
(Press once)
3
Needle up stop position setting
・ If you press the key, the setting value will
increase and the needle up stop position will
become lower.
・ If you press the key, the setting value will
decrease and the needle up stop position will
become higher.
・ The setting range is from –5 to 10.
* A setting value of “10” corresponds to an angle of
rotation of approximately 10° for the upper shaft.
4
The setting will be stored and the display will return
to the setting item.
5
Normal sewing machine operation will then be
possible.
4206M
* For details on other adjustment items, refer to the Service Manual.
2194B 2138M 2139M
Becomes higher
Becomes lower
4217M
2138M
(Setting value)
(Setting item)
(Setting item)
Example:
2193B
4220M
To Next Page
Loading...
Need help?
General
