Chapter 3 Preparation Function TC-32B
2004/01/22 3 - 32 eTCOMNCPR3.doc
3
(3) Input of tool fine offset value
When tool length /Tool diameter compensation command is issued using the program, the data of
the fine offset number corresponding to the commanded offset number is automatically reflected
in operation.
Change of tool fine offset data in program
Command format G10L11 P_ R_ ;
G10L13 P_ R_ ;
L11 : Fine offset of tool length
L13 : Fine compensation of tool diameter
P : Fine offset No.
Range : 1~99
R : Fine offset amount
The commanded value is added to the compensation amount in absolute
mode (G90) nd the preset value in incremental mode (G91).
Setting range +/- 99.999 mm +/- 9.9999 inch
(4) Input of measured working coordinate zero point data.
Command format G10L99 Pn X_ Y_ Z_ Q_ ;
n=1 : G54
n=2 : G55
n=3 : G56
n=4 : G57
n=5 : G58
n=6 : G59
Q : The number that stores the measured results.
After automatic measurement (G121 to G129), set the coordinate system based on
the measured position.
Input of additional working coordinate
Command format G10L99 Pn X_ Y_ Z_ Q_ ;
n : Additional working coordinate system (1 to 48).
Q : The number that stores the measured results.
Ex.) Assume that automatic measurement is carried out on the G54 coordinate system and the
measurement result turned out to be (120, 80). Set the coordinate system that this position will
be (50, 50).
(Program)
:
:
G54 G121 X100. Y100. I20. J20. Z-10. R10. ; (Corner measurement)
G10 L99 X50. Y50. ;
:
:
To Next Page
Loading...
Need help?
General