Brother TD-2020 - Page 28

III - 14
(3) Remove the filament tape 3M #893.
(4) Pull out each harness from the hole of the roll cover inner and release them from
the securing fixtures.
(5) Turn over the roll cover outer B.
(6) Remove the two taptite bind B M2.6X8 screws to remove the FG harness ASSY.
Release the hook to remove the panel PCB ASSY from the roll cover outer B.
(7) Remove the button A, button B, status button, and two LED lenses from the roll
cover outer B.
Figure 3.4-12
FG harness ASSY
Taptite bind B M2.6X8
Panel PCB ASSY
Button A
Status button
LED lenses
Roll cover outer B
Button B
Roll cover inner
Hook
Filament tape 3M #893