Brother TD-2020 - 9 Using the RJ25 to DB9 M Serial Adapter (Optional:pa-SCA-001); Connecting the Computer and Printer with the RJ25 to DB9 M Serial Adapter; Product Specifications

68
9
Connecting the
Computer and Printer
With the RJ25 to DB9M
Serial Adapter
9
a Before connecting the serial cable,
make sure that the printer and the
computer are turned off.
b Connect the RJ25 side of the adapter to
the printer.
c Connect the printer end of the serial
cable to the DB9M side of this adapter.
d Connect the other end of the serial cable
to the serial port on the computer.
NOTE
• The default communication settings are
as follows:
Baud rate: 9600bps
Parity: None
Bit length: 8 bits
Flow control: Hardware
• To change the communication settings,
use [P-touch Template settings] in the
“Printer Setting Tool” - [Communication
settings]. For details, see the P-touch
Template Command Reference.
The latest versions can be downloaded
from the Brother Solutions Center
website.
http://solutions.brother.com/
Select the product, and then select
[Manuals].
Product Specifications 9
Converts to a D-sub 9-pin male connector.
1 RJ25 to DB9M serial adapter
Using the RJ25 to DB9M Serial
Adapter (Optional:PA-SCA-001)
9
Be sure to use the cable designed for
your Brother optional product.
1