Brother TD-2020A - Button Functions

Printing
5
2
Button Functions 2
(Power) button functions
Operation
Turn the printer on
While the printer is turned off, press the (Power) button. The
POWER indicator turns on.
Turn the printer off
While the printer is turned on, press and hold the (Power) button
until the POWER indicator turns off.
If the [Auto Power Off] function is specified in [Device settings] of the
“Printer Setting Tool”, the printer will turn off automatically after the
specified period of inactivity.
(Feed) button functions
Operation
Feed the paper When the paper type is set to [Die-cut Label] or [Media With Marks]:
Press the (Feed) button to automatically feed the paper to the print
position.
When the paper type is set to [Continuous Length Tape]:
Press the (Feed) button to automatically feed the paper
approximately 25.4 mm.
NOTE: The default setting is [Continuous Length Tape].
Use [Paper Size Setup] in the “Printer Setting Tool” to register the
paper size information with the printer. For more information, see
Registering Paper Size Information with the Printer on page 3.
Enable/disable Wi-Fi/Bluetooth or
both connection (TD-2125NWB/
2135NWB only)
To enable or disable the wireless LAN, Bluetooth, or both connection
enable/disable, press and hold the (Feed) button for five seconds.
(TD-2125NWB/2135NWB only)
Setting up Wi-Fi Protected Setup
(WPS)
To enable Wi-Fi Protected Setup (WPS), press and hold the (Feed)
button for ten seconds.
(Print) button functions
Operation
Perform a specified operation
With the printer idle, press the
(Print) button to perform the
operation specified in [Device settings] of the “Printer Setting Tool”.
For more information, see Print Key Function on page 29.
Print the printer setup information
Make sure that a Media Roll is installed, and then press and hold the
(Print) button to begin printing the printer setup information. For more
information, see
Printing the Printer Setup Information on page 11.
Execute a command file stored in
the mass storage area
With the printer in mass storage mode, press the
(Print) button to
execute a command file stored in the mass storage area.
Resetting the incrementing field
Press and hold the (Print) button, until the POWER and STATUS
indicators flash 3 times in orange.