30
THE TEN COMMANDMENTS OF OPERATION
1. ALWAYS - Read and understanding the owners manual before operating this
or any other equipment.
2. ALWAYS – Attach this equipment to a tractor that has suitable safety
equipment properly installed.
3. ALWAYS – Operate this equipment with all safety devices properly installed
on this equipment.
4. ALWAYS – Inspect, walk, ag or remove all foreign material from job site
before starting the cutting process.
5. NEVER – Allow any riders or bystanders within 300 feet of this unit during
operation.
6. ALWAYS – Check all bolts, fasteners, ttings and oil levels before beginning
operations each day.
7. NEVER – Allow blades to make contact with rocks or stumps – unit was not
designed for this type of operation.
8. NEVER – Allow an untrained operator to operate this equipment.
9. ALWAYS – Install only genuine Brown replacement parts.
10. ALWAYS – Remain on tractor seat until blades have stopped turning and all
tractor shut down procedures have been completed.
THESE ARE ONLY A FEW OF THE SAFETY PROCEDURES THAT MUST BE
FOLLOWED TO INSURE THE SAFE OPERATION OF THIS EQUIPMENT – MANY
OTHER SAFETY RELATED POINTS ARE STATED THROUGHOUT THIS MANUAL
WARNING: FAILURE TO FOLLOW THE TEN COMMANDMENTS
CAN AND WILL CAUSE SERIOUS INJURY OR DEATH
IF YOU HAVE ANY SAFETY, MAINTENANCE OR OPERATIONAL QUESTIONS –
PLEASE CALL THE FACTORY BEFORE USING THIS EQUIPMENT – 1-800-633-8909
To Next Page
Loading...
