CLEANING AND MAINTENANCE SUGGESTIONS
NOTICE! please take nOte Of the fOllOwing infOrmatiOn befOre
Cleaning yOur firearm.
CLEANING PARTS WITH SPECIAL FINISHES
Be especially careful when cleaning guns with camouflage,
Dura-Touch
®
Armor Coating and other special finishes. Always
prevent these surfaces from coming in contact with cleaning solvents,
barrel scrubbers and other strong chemicals. It is preferable to clean
these surfaces with a light gun oil containing no solvents or with a
damp cloth and mild dish soap (be sure to keep water out of the
action). When cleaning your firearm’s bore and action, protect the
external finishes from any contact with chemicals used. Also avoid any
contact between external finishes and other strong chemicals like
those found in DEET-containing insect repellents, sunscreens, etc.
Damage to camouflage, Dura-Touch and other finishes caused by
chemicals is irreversible and not repairable.
befOre perfOrming Cleaning prOCedures, plaCe the “safety” in
the On safe pOsitiOn. Open the aCtiOn and make Certain yOur
shOtgun is COmpletely unlOaded. keep the muZZles pOinted in a
safe direCtiOn. failure tO fOllOw these warnings COuld result
in seriOus injury Or death.
wear eye prOteCtiOn when disassembling and Cleaning yOur
shOtgun tO prevent sOlvents Or Other agents frOm COntaCting
yOur eyes, resulting in injury.
keep all ammunitiOn away frOm the Cleaning area. never test
the meChaniCal funCtiOn Of yOur rifle with live ammunitiOn.
failure tO fOllOw these warnings COuld result in seriOus
injury Or death.
Several choke tubes are supplied with your shotgun. The choke tubes
listed are also available as accessories. Remember, Standard Invector
and Invector-Plus tubes are not interchangeable. Invector-Plus tubes
are for Browning shotguns with back-bored barrels only. Before
removing or installing tubes, or reading the rim notch code, make sure
your shotgun is fully unloaded.
CHOKE TUBE REMOVAL
1 Place the “safety” in the rearward, on safe position. Always make
sure the shotgun is completely unloaded. Keep the muzzle pointed
in a safe direction.
2 Use the choke tube wrench to loosen the tube, turning it
counterclockwise. Finger-twist the tube the rest of the way out
of the barrel.
CHOKE TUBE INSTALLATION
1 Place the “safety” in the rearward, on safe position. Always make
sure the shotgun is completely unloaded. Keep the muzzle pointed
in a safe direction.
2 Before installing a tube, check the internal choke tube threads in
the muzzle, as well as the threads on the choke tube to be sure they
are clean. Lightly oil the threads with a high-quality, lightweight
gun oil.
3 Using your fingers, screw the appropriate tube into the muzzle
end of the barrel, tapered end first and notched end outward.
When it becomes finger-tight, use the choke tube wrench to firmly
seat the tube.
NOTICE! the ChOke tube shOuld be periOdiCally CheCked tO
assure that it is tight and firmly seated. befOre CheCking,
fOllOw all the ChOke tube remOval and installatiOn safety
guidelines previOusly Outlined.
To Next Page
Loading...